![]() ![]() With a maximum of 1 command, only 1 MAC address will be stored and Port Security will be provided.With the Mac-address sticky command, the MAC addresses of the computers connected to the interfaces are automatically stored.The interface is set to access mode with the Switchport Mode Access command.Port Security is activated in FastEthernet0/1 and FastEthernet0/2 interfaces on the switch.If we explain the above configuration commands Switch(config-if)#switchport port-security violation shutdown Switch(config-if)#switchport port-security maximum 1 Switch(config-if)#switchport port-security mac-address sticky Switch(config-if)#switchport port-security ![]() Switch#configure terminalĮnter configuration commands, one per line. After the connection test, click on the Cisco Switch.Ĭlick on the Switch to open the CLI prompt, and then execute the following commands to enable port security. Similarly, test the connection with Ping from PC1. Ping the PC0 to the Router interface and PC1 to test the connection. Open Cisco Packet Tracer and add one Router, Switch and two computers to the workspace, then assign the IP address to the Cisco Router.īefore enabling Port Security, test the network connection between clients. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |